Nextar XPJ Manuel d'utilisateur télécharger pdf (Page 11)

Remote control effective range

Infra-Red (IR) remote control sensors are located on the front and the back of the projector.

The remote control must be held at an angle within 30 degrees of the projector’s IR remote control sensors to

function correctly. The distance between the remote control and the sensors should not exceed 6 meters (~

20 feet).

Make sure that there are no obstacles between the

remote control and the IR sensors on the projector

that might obstruct the infra-red beam.

Replacing the remote control battery

1. Pull out the battery holder.

2. Insert the new battery into the holder. Note:

The positive polarity should face outward.

3. Push the holder into the remote control

until it clicks into place.

λ Avoid excessive heat and humidity. There

may be battery damage if the battery is

incorrectly replaced.

λ Replace only with the same or equivalent type

battery, as recommended by the battery manufacturer.

λ Dispose of the used battery according to the manufacturer’s instructions.

λ Never throw a battery into a fire. There may be danger of an explosion.

λ If the battery is dead, or if you will not be using the remote control for a long time, remove the battery to

prevent damage to the remote control from the possibility of battery leakage.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 24 25

Pas de commentaire

Nextar XPJ Manuel d'utilisateur Page 11